User guide

5.3 Set-up Mode Switches and Indicators

In set-up mode, the control panel performs the functions that appear in letters

and arrows below the switches.

Set-up Switch

To put the printer in set-up mode, press the Set-up switch while turning the

printer on. After you have changed the printer’s conﬁguration, press the Set-up

switch again to save the new values and to exit set-up mode.

Up-arrow and Down-arrow Switches

Press the Up-arrow and Down-arrow switches respectively upwards and

downwards through the features when you are setting the printer’s

conﬁguration.

Right-arrow and Left-arrow Switches

Press the Right-arrow and Left-arrow switches to scan respectively forwards

and backwards through the values when you are setting the printer’s

conﬁguration.

5.3.1 Changing the Printer’s Conﬁguration (Set-up Mode)

Note: Before beginning the set-up procedure, make sure that the power switch

is set to 0 (off) and that paper is advanced to the print position.

1 Press and hold down the Set-up switch while setting the power switch to 1

(on).

The Serial Port and Draft indicators ﬂash.

The printer automatically does the following:

Prints a list of the features and values stored in its memory. (See

Section 7.4 in Chapter 7.)

Prints the ﬁrst feature in the list (Protocol: DEC Emulation, or

port-dependant).

2 Press the Right-arrow or Left-arrow switch to select the next or previous

value.

3 Press the Up-arrow or Down-arrow switch to access the feature you wish to

change.

5–4 Conﬁguring the Printer