User guide

5.1.1 Determining the Printer’s Configuration
Check your computer system’s documentation to determine what your system
requirements are for protocol, baud rate, and data bits and parity. (These are,
respectively, Generic Features 1, 7, and 8 in Set-up.)
You can see what is programmed into your LA75 Plus’s set-up memory by
following these instructions:
1 Turn the power switch to 0 (off).
2 Press and hold the Set-up switch while you set the power switch to 1 (on).
The LA75 Plus prints a list of what is in its set-up memory. See the tables
in Section 7.4 in Chapter 7 for examples of what information is stored in
set-up memory.
3 Press the Set-up switch to exit Set-up mode.
4 Compare the printer’s current configuration with the requirements of your
computer or video terminal. Read Section 5.3 if you need to change the
printer’s set-up memory.
Quiet/
Quality
LQ
Protocol LFDEC
Draft
QuietFault
RDY
Serial Port
Set-up
Ready
FF
5–2 Configuring the Printer