User guide

Physical Page Characteristics of the LA600 MultiPrinter
16.4 Paper Tray Selection (DECSITF)
16.4 Paper Tray Selection (DECSITF)
The LA600 supports the command Select Input Tray Failover (DECSITF).
When all of the paper trays in the composite tray definition are empty, a
‘‘paper out’’ condition occurs. Printing resumes when any of these trays is
reloaded.
The LA600 supports the Ps2–Psn values from 1 to 3, with a maximum of 3
parameters. The printer does not support the combination Ps2, Ps3=1,3.
DECSITF causes a conditional sheet feed.
16.5 Paper Exit Control (DECPEC)
The LA600 supports the Paper Exit Control command, which applies to cut
sheets only, as defined in Table 16–2.
Table 16–2 Ps Parameters for DECPEC
Ps Selected Paper Exit
0 or 1 Paper stacker (top)
2 Front paper exit—confirmed by Start/Stop
1
3 Front paper exit—not confirmed by Start/Stop
2
1
To resume printing, the user must remove the printed cut sheet from the front paper exit and
press the Start/Stop key on the Operator Panel.
2
The application controls the printing of the next sheet.
16.6 Printhead Gap Control (DECPHGC)
The LA600 supports the Printhead Gap Control (DECPHGC) command,
which sets the distance between the printhead and the platen, as defined in
Table 16–3.
Table 16–3 Ps Parameters for DECPHGC
Ps Selected Mode
0 Automatic Gap Control (AGC)
1–6 Programmable Copy Control (PCC), defined by number of copies
The default mode is AGC. The AGC procedure is automatically activated when
the paper is inserted and one of the following conditions occurs:
16–4 Physical Page Characteristics of the LA600 MultiPrinter