User guide

Initial State Values for the LA310 MultiPrinter
10.1 Initial States
Table 10–1 (Cont.) Initial State Values for LA310
Variable or
Control Function DECSCL Power-Up
DECSTR
RIS
Recall
Factory
Defaults
(Setup)
Horizontal tabs
3
Every eight Every eight Every eight Every eight
Line Feed/New Line Reset NVM NVM Reset
CR/New Line Mode Reset NVM NVM Reset
SGR attributes Disabled Disabled Disabled Disabled
Density (DECDEN) Draft NVM NVM Draft
(Software
control)
Unidirectional Print
Mode
Reset Reset Reset Reset
Vertical tabs
4
Every line Every line Every line Every line
G0 character set ASCII NVM NVM ASCII
G1 character set ASCII ASCII ASCII ASCII
G2 character set User Pref. User Pref. User Pref. User Pref.
G3 character set User Pref. User Pref. User Pref. User Pref.
GL character set G0 G0 G0 G0
GR character set G2 G2 G2 G2
User Preference Set DEC Supp. NVM Unchanged DEC Supp.
Autowrap Mode Set NVM NVM Set
Unsolicited status
reports
Disabled Disabled Unchanged Disabled
Initialization Message Unchanged NVM Unchanged Disabled
Downloaded fonts Deleted None Unchanged None
Typestyle (SGR #) 10 NVM NVM 10
Auto Advance Unchanged NVM Unchanged Disabled
3
Horizontal tabs are set every eight columns, starting with column 9 (9,17, . . . ). All entries in
the tab table are initialized. Initializing only those entries that are addressable on the currently
selected paper size is incorrect.
4
Vertical tabs are set every line or Vertical Advance Increment (VAI). All entries in the tab table
are initialized. Initializing only those entries that are addressable on the currently selected paper
size is incorrect.
(continued on next page)
10–2 Initial State Values for the LA310 MultiPrinter