User guide

10
Initial State Values for the LA310
MultiPrinter
This chapter lists the values used by the LA310 MultiPrinter printer for:
• A power-up reset or a recall of factory default values
• The Select Conformance Level (DECSCL) command
• The Soft Terminal Reset (DECSTR) or Reset to Initial State (RIS)
commands
10.1 Initial States
Table 10–1 lists the initial state values used by the LA310 MultiPrinter. The
printer always powers up in Ready mode if no error is detected.
Table 10–1 Initial State Values for LA310
Variable or
Control Function DECSCL Power-Up
DECSTR
RIS
Recall
Factory
Defaults
(Setup)
Protocol Unchanged NVM
1
Unchanged Port
Dependent
Origin (DECHPWA) Unchanged 0 Unchanged 0
Vertical pitch 6 lpi NVM NVM 6 lpi
Horizontal pitch 10 cpi NVM NVM 10 cpi
Active position Origin Origin Origin Origin
2
1
NVM indicates that the initial state value is stored in the nonvolatile memory of the LA310.
2
Device performs conditional form feed on exit from setup
(continued on next page)
Initial State Values for the LA310 MultiPrinter 10–1