User guide

Commands (cont’d)
DA2R (Secondary Device Attributes
Report), 4–2, 11–2, 18–2
DAR (Device Attributes Report), 4–1,
11–1, 18–1
DECASFC (Automatic Sheet Feeder
Control), 2–4
DECAUPSS (Assign User Preference
Supplemental Set), 5–1
DECBAR (Start or Stop Bar Codes), 20–2
DECDEN (Density Selection), 5–6, 12–4,
19–5
DECDLD (Download Font), 5–6, 12–5
DECFSR (Font Status Report), 5–6
DECGRA (Set Raster Attributes), 6–2,
13–2, 21–2
DECSBCA (Select Bar Code Attributes),
5–8, 20–2
DECSCL (Select Conformance Level),
3–1, 10–1, 17–1
DECSLPP (Set Lines per Physical Page),
2–1, 9–1, 16–1
DECSTR (Soft Terminal Reset), 3–1,
10–1, 17–1
DECVERP (Set Vertical Pitch), 2–4, 9–3,
16–6
DSR (Device Status Report), 4–3, 11–3,
18–3
RIS (Reset to Initial State), 3–1, 10–1,
17–1
SGR (Select Graphic Rendition), 5–5,
12–4, 19–4
Control characters
LA310, 14–1
LA600, 22–1
LA75 Plus, 7–1
D
Data character format, A–2
Data communication interfaces, A–1
Data synchronization, serial, A–2
DECASFC, response to
LA75 Plus, 2–5
DECAUPSS (Assign User Preference
Supplemental Set) command
LA75 Plus, 5–1
DECDLD (Download Font) command
LA310, 12–5
LA75 Plus, 5–6
DECLANS (Load Answerback) command,
C–2
DECPEC (Paper Exit Control) command,
C–5
DECPHGC (Printhead Gap Control)
command, C–6
DECPSP (Proportional Spacing Mode)
command, C–4
DECSCL (Select Conformance Level)
command
LA310, 10–1
LA600, 17–1
LA75 Plus, 3–1
DECSITF (Select Input Tray Failover)
command, C–7
DECSLPP (Set Lines per Physical Page)
command
LA310, 9–1
LA600, 16–1
LA75 Plus, 2–1
DECSTR (Soft Terminal Reset) command
LA310, 10–1
LA600, 17–1
LA75 Plus, 3–1
Density Selection (DECDEN) command
LA310, 12–4
LA600, 19–5
LA75 Plus, 5–6
Device Attributes Report (DAR)
LA75 Plus, 4–1
Device Attributes Report (DAR) command
LA310, 11–1
LA600, 18–1
Device Status Report (DSR)
LA75 Plus, 4–3
Device Status Report (DSR) command
LA310, 11–3
LA600, 18–3
Index–2