User guide

22
Control Characters for the LA600
MultiPrinter
This chapter describes the control characters for the LA600 MultiPrinter and
their functions. The control characters are:
• EOT, described in Section 22.1
• ENQ, described in Section 22.2
Note
Although the LA600 MultiPrinter has an audio indicator, the device
ignores the bell (0/7) command received from the host.
22.1 EOT
When ‘‘EOT DISCONNECT’’ is enabled by the setup facility, the DTR signal on
the serial port is dropped for 5 seconds when the End of Transmission (EOT)
control code is received. This feature applies only if the serial port is active.
22.2 ENQ
When ‘‘ANSWERBACK/ENQ’’ is enabled by the setup facility, the answerback
message is sent by the printer on receipt of the Enquire (ENQ) character. This
feature only applies when the serial port is active. See the Load Answerback
(DECLANS) command in Appendix C.
Control Characters for the LA600 MultiPrinter 22–1