User guide

Initial State Values for the LA600 MultiPrinter
17.1 Initial States
Table 17–1 (Cont.) Initial State Values for LA600
Variable or
Control Function DECSCL Power-Up
DECSTR
RIS
Recall
Factory
Defaults
(Setup)
GR character set G2 G2 G2 G2
User Preference Set DEC Supp. NVM NVM DEC Supp.
Autowrap Mode Set NVM NVM Set
Unsolicited status
reports
Disabled Disabled Unchanged Disabled
Initialization message Disabled NVM NVM Disabled
Typestyle (SGR #) 10 NVM NVM 10
CRM Unchanged Disabled
5
Unchanged Disabled
C1 Receive 8-Bit 8-Bit Unchanged 8-Bit
Device ID (DA) Unchanged NVM NVM DEC PPL2
Form length 11" NVM NVM 11"
Paper Source
(DECASFC) and Tray
Failover (DECSITF)
Unchanged NVM NVM Tractor
Paper Exit (DECPEC) Unchanged NVM NVM Stacker
Printhead Gap Control
(DECPHGC)
AGC mode AGC mode AGC mode AGC mode
Margins Paper edge NVM NVM Paper edge
Answerback message Unchanged NVM Unchanged Message
unchanged in
NVM
7
Answerback/ENQ Unchanged NVM NVM Message
unchanged in
NVM
7
Tear off Unchanged NVM NVM Disabled
Pre-Separation Unchanged NVM NVM Disabled
5
Note that, when CRM is enabled by software, it can be disabled only by software or by powering
down the printer. Protocol switching commands that would cause a reset are not performed when
CRM is enabled. The LA600 can also enable DUMP printing from the printer front panel. This
mode cannot be disabled by software.
7
The factory default answerback message is no answerback message. The LA600 will send no
message even if answerback is enabled through Set-Up.
(continued on next page)
Initial State Values for the LA600 MultiPrinter 17–3