Service manual

LA600 Field Service Manual
3. Procedures for Removal and Reassembly
This chapter describes the removal procedures which are necessary for proper
handling of the spare parts and subunits of the printer.
Note:
All removal procedures consists of several steps indicated with a:
to show preparation and
⇒ to indicate the main removal steps.
Digital Equipment Corporation Page 3-1
LA600 Field Service Manual
Part: Housing DEC P/N: FD-W03RF-01
Part No: 5112 292 38200
REMOVAL
Disconnect mains cable
Remove the manual front insertion (A)
⇒ Remove the front cover (B) resp. the ASF cassette(s) out of the
mounting slots (C)
⇒ Swing cover (D) to its nearly upright position and remove it
⇒ a) Remove the cover (E) by releasing the cover snap locks
(F) with a flat bladed screwdriver
b) To remove the cover (E) grasp it by the sides, raise the
front slightly, push the cover back until the metal snaps
are out of the slots at the rear of the printer and then lift
the cover
REASSEMBLING
Execute the REMOVAL procedure in reverse sequence
Page 3-2 Digital Equipment Corporation