Service manual

LA600 Field Service Manual
Digital Equipment Corporation Page 3-61
LA600 Field Service Manual
Part: Kit ASF Lever DEC P/N: FD-W04B7-01
Part No: 5112 292 22480
REMOVAL
⇒ Remove the AFS-Cassette from the printer and remove any paper
loaded, and the paper support (if mounted).
⇒ Remove the side cover of the ASF Cassette by releasing of four
snaplocks (No.1-4infigure 1). Use a flat screw driver to do so
and keep the sequence of figure 1.
⇒ Remove the circlip (No. 4 in figure 2) of the lever shaft.
⇒ Push the bar against the opposite side to release the mounted
levers. Snap the levers of the bar using a screw driver.
REASSEMBLING
⇒ a) Assemble the three levers together (figure 3). Lever 2
(upper paper release) onto lever 1 (paper pressure lever),
and lever (lower paper release) onto lever 2. Observe that
the little plug of lever 2 is fitted in the hole provided in
lever 3.
b) Snap the assembled levers into the ASF Cassette. Be
careful to mount the snaplock of the paper pressure lever
(lever 1) in one of the holes provided in the sidewall of the
cassette (figure 4).
c) Push the bar back into the levers and adjust the flat side of
the bar accordingly.
d) Secure the levers using the circlip and snap the flat side of
the ASF Cassette in place again.
Page 3-62 Digital Equipment Corporation