Service manual

LA600 Field Service Manual
Digital Equipment Corporation Page 3-57
LA600 Field Service Manual
Part: Kit Tractor 40A DEC P/N: FD-W02M8-01
Part No: 5112 292 38470
REMOVAL
Disconnect mains cable
Remove all encasing parts (see Part: Housing)
Snap out the paper supports (C)
⇒ a) Locate the bearing (A) and (B) on the left side of the printer
b) Press the two locking tabs on the bearing (A) and remove it
c) Press the three locking tabs on the bearing (B) and remove
it
d) For removal slide the entire tractor kit first to the left and
then remove it by sliding out to the right.
REASSEMBLING
Execute the REMOVAL procedure in reverse sequence
Note: Pay attention that the mounting position of the left tractor is
between the stoppers (D). When you insert the square shaft, the
white dot on the left and right hand tractor must have the same
position to ensure synchronous running of the belts
Page 3-58 Digital Equipment Corporation