Service manual

LA600 Field Service Manual
Digital Equipment Corporation Page 3-25
LA600 Field Service Manual
Part: Horizontal Motor 40A DEC P/N: FD-W0396-01
Part No: 5112 292 37910
REMOVAL
Disconnect mains cable
Remove all encasing parts (see Part: Housing)
Remove DEV-40 Assy (see Part: DEV-40 LA600 Assy)
⇒ a) Disengage the drive belt (A) from the drive wheel of the
horizontal motor by pressing the belt tension element (B),
which is located at the left side of the engine, upwards
b) Pull off the belt from the wheel
c) Disconnect the two pin motor cables (C) from the motors
connector (D)
d) Remove the two cables from the motor fixing plate (E)
e) Remove the horizontal motor Assy
REASSEMBLING
Execute the REMOVAL procedure in reverse sequence
Note: Pay attention that the cable installation is correct (Detail Y)
Page 3-26 Digital Equipment Corporation