Service manual

see Note!

Field Service Instruction

7-66 7-67

Part: Rep Kit ASF-Cassette Part No.: 5112 292 7235X

DEC P/N.: ____________

REMOVAL

" Remove the ASF-Cassette from the printer. Remove any paper loaded and

the paper support (if mounted).

Y M Remove the cover (1) of the ASF-Cassette by releasing the snaplocks

(2). Use a flat screw driver to do so.

Y M Release the connector (3) out of the cover (1).

Y M Pull back the retaining parts (5) and remove the shaft (4).

Y M Remove the belt from the pulley (6) and remove the pulley.

Y M Cut the rest of the broken shaft (7) as well as the second (non broken)

shaft. Use a side nippers to do so. The remaining rest of both shafts

must not exceed 0.7 mm.

Y M Remove the female screw (13) and the washer (12) from the screw (11).

Y M Mount the metal part of the Rep. Kit ASF-Cassette (8) by inserting the

screw (11) into the hole (9).

Note: Mount the Rep. Kit ASF-Cassette (8) in the same orientation as

shown in the figure. Lift the metal part (8) up to the highest position,

nearly to the edge (16).

Y M Put a washer (12) on the screw and tighten the female screw (13).

Y M Mount the gears (10) and (15) as shwon in the figure and fix the

gear (15) with the snap-ring (14).

REASSEMBLING

Y M Assemble the pulley (6) and the belt.

Y M Execute now the REMOVAL procedure in reverse sequence.

5112 991 15321