Service manual

Figure 4

Figure 5

right

left

Figure 2

Figure 3

Figure 1

DEC Field Service Instruction

7-58 7-59

Part: Kit ASF Lever 2 Part No.: 5112 292 6875x

DEC P/N.: FD-W0487-01

REMOVAL of the Force Adjustment Levers (Figure 2)

" Remove the ASF-Cassette from the printer and remove any paper loaded,

and the paper support (if mounted).

Y M Remove the lever-side cover of the ASF Cassette by releasing of the

four snaplocks (No. 1 - 4 in figure 1). Use a flat screw driver to do

so and keep the sequence of figure 1.

Y M Remove the circlip (No. 4 in figure 2) of the lever bar.

Y M Slide out the bar to the direction of the connector and snap the

lever out of the encasing.

REASSEMBLING of the Force Adjustment Levers (Figure 2)

Y M Assemble the three levers together (figure 3). Lever 2 (upper paper

release) onto lever 1 (paper pressure lever), and lever 3 (lower

paper release) onto lever 2. Observe that the little plug of lever 2 is

fitted in the hole provided in lever 3.

Y M Execute now the REMOVAL procedure in reverse sequence.

REMOVAL of the Locking Levers (Figure 5)

Y M Remove the ASF-Cassette from the printer and remove any paper

loaded, and the paper support (if mounted).

Y M Remove both side covers of the ASF Cassette by releasing of each

snaplocks (No. 1 - 4 in figure 1).

Y M Slide out the bar to the direction of the connector and release both

paper guides to exchange the locking levers.

REASSEMBLING of the Locking Lever (Figure 5)

Y M Insert the left and right locking lever into the paper guides.

Y M Push the bar through the locking levers, the paper guides, and the

support springs underneath the paper guides. Take care, that all

parts are properly adjusted.

Y M Execute now the REMOVAL procedure in reverse sequence.

5112 991 15071