Service manual

1
2
2
1
3
DEC Field Service Instruction
7-46 7-47
Part: Kit Pressure Rolls Part No: 5112 292 6655x
DEC P/N.: 29-31801-01
REMOVAL
" Disconnect mains cable
" Remove all encasing parts (see Part: Housing)
" Remove the encoder strip (see Part: Encoder Strip)
Y M Remove the upper screws (1)
Y M Remove the foam under the neath of printhead cable
Y M Loosen the two screws (2) and remove the metal sheet coner
Y M Snap out the springs (3) using a knife
Y M Remove the pressure roller
Y M Grease the bearings of the pressure roller with Molykote DX or a
similar type of grease
Y M Grease the arms of the new springs at the positions which are in
contact with the FF1 roll with Molykote DX or a similar type of
grease
Y M Insert the new springs by snap in
REASSEMBLING
" Execute the REMOVAL procedure in reverse sequence
5112 991 12402