Service manual

Detail A

DEC Field Service Instruction

7-36 7-37

Part: Stepper Motor 7.5 DEG Part No.: 5112 292 4106x

(Platen gap control) DEC P/N.: FD-W0394-01

REMOVAL

" Disconnect mains cable

" Remove all encasing parts (see Part: Housing)

" Remove DEV-40A (see Part: DEV-40)

Y M Disconnect the four pin motor cables from the motors plug

Y M Remove the two screws (1) fixation of the stepper motor

Warning: Do not loosen the screw (2). This is a factory adjustment;

field adjustment is impossible

Y M Remove the stepper motor

REASSEMBLING

" Execute the REMOVAL procedure in reverse sequence

Note: Make sure that the cable installation is correct (Detail A)

5112 991 10583