Service manual

1112

DEC Field Service Instruction 5112 991 10723

7-26 7-27

Part: Print H-Encoder Part No.: 5112 292 4310x

DEC P/N.: FD-W0290-01

REMOVAL

" Disconnect mains cable

" Remove all encasing parts (see Part: Housing)

" Remove encoder strip (1) (see Part: Encoder Strip)

Y M Remove the noise reduction foam (2)

Y M Remove at the left and right side the upper screws (5)

Y M Loosen at the left and right side the screws (6) and remove the

mounting plate (7)

Y M Move the carriage to the cutout (8)

Y M Remove the two screws (9) from the carriage

Y M Remove the screw (10) and the cable clamp from the carriage

Y M Disconnect the print head cable from the head

Y M Clip the plastic support (11) from the carriage and disconnect the

wire-to-wire connector (12) H-Encoder/print head cable

Y M Remove the print head H-encoder

REASSEMBLING

" Execute the REMOVAL procedure in reverse sequence

Note: Pay attention that the logic cable is fixed correctly by clamp

(10)