User guide

Configuring the Printer
4.3 Set-up Mode Buttons and Indicators
The entry ONE BEEP is bolded as it is the default setting.
5. Press to move to the THREE BEEPS setting, and press to select it.
The selected item is underlined, the printer enters the GENERAL menu,
and the red triangle points to the ERROR BEEP submenu:
4.3.4 Saving New Values and Exiting Set-up Mode
Pressing the Set-up switch once while in Set-up mode stores your set-up
changes in the printer’s memory, exits Set-up mode, and automatically returns
the printer to print mode.
NOTE: If you switch off the printer, or if the power is otherwise interrupted
before you press the Set-up switch, no changes are stored in the printer’s
memory.
4.3.5 Recalling the Factory Defaults
To recall factory default settings, from the Set-up Directory:
1. Use or to move the red triangle to the FACTORY DFLT setting.
2. Press .
Refer to the table of factory set-up defaults in Appendix A for full details of
all factory defaults.
Configuring the Printer 4–7