Specifications

5-4
At power on, the carriage does not move.
1. Make sure the access cover is seated correctly.
2. Logic may not be receiving the access cover switch signal.
a. Make sure the connection between the operator panel and the Main Board is good.
b. Replace the Operator Panel.
c. Replace the Main Board.
3. Make sure the printhead carriage can move. Push and pull from sideto side. It
should move freely. If not:
a. Remove any visible obstruction.
b. Replace the Mechanical Assembly.
Printing does not start.
1. Make sure the READY indicator is on. If not , press the READY switch.
Printing should start when you send data from the host computer.
2. Make sure the printer is connected to the host computer.
3. Make sure the host computer can send data.
4. Make sure you have selected the correct protocol.
5. Make sure you have selected the correct port.
6. Logic may not be receiving the READY signal.
a. Make sure the connection betweeen the operator panel and the Main Board is
good.
b. Replace the operator Panel Board.
7. Logic may not be able to respond to READY signal. Replace the Main Board.
8. Replace the Mechanical Assembly.