Specifications

LA 310 - Service Manual
2-13
Bail Bar
The bail bar holds the paper against the platen as it is fed through the printer.
When loading any paper, check that the rollers on the bail bar are positioned correctly
for the loading operation. They must be positioned in the grooves on the bail bar as
follows:
Width of paper
used Recommended settings
8 inches Set Paper Width Setup feature to 8".
Put the rollers on the bail bar in the grooves on the bar that are
marked at ruler positions of approximately 40 and 90. This centers
the printhead plastic guide on the rollers.
More than 8 Set Paper Width setup feature to 13.6".
inches Put the rollers on the bail bar in the grooves on the bar that are
marked at ruler positions of approximately 40 and 90. This centers
the printhead plastic guide on the rollers.
Less than 8 Set the Paper Width setup feature to 1-8". This causes the default
inches printhead to be aligned with the paper sensor mark. Put the rollers
on the bail bar in the grooves on the bar that are marked at ruler
positions of approximately 20 and 60.
Note: If you do not use the correct settings, there is a high risk of the top of the
paper jamming against the bail bar.
Fig. 2.11 Bail Bar Settings