User`s guide
Peripheral Devices
4-5
Parallel Port Data Transfers
When using Puma TranXit version 2.0 (or higher) to conduct parallel port data transfers
under Windows for Workgroups, you must enter the BIOS Setup Program and configure
the Parallel Port to EPP mode. For detailed information on changing the Parallel Port
mode, please refer to Chapter 3, Integrated Peripherals.
Connecting a Serial Mouse
The notebook has one Serial Port. Its address can be set through the BIOS Setup program
(refer to Chapter 3 for information on BIOS Setup). Connect a serial mouse as follows:
1. Connect the mouse cable to the notebookâs serial port located on the rear of the
notebook. (Figure 4-3)
2. Tighten the thumb screws.
Figure 4-3: Connecting a Serial Mouse