Technical data

FRU Replacement
4–12
Digital HiNote VP 500 Service Guide
Removing the LCD Display Bezel
To remove the LCD display bezel:
1. Remove the two plugs and screws (Figure 4-11).
2. Pull one side of the bezel away from the center of the LCD assembly until the plastic
latches are disengaged. Do this on each side of the bezel until you can remove the bezel.
Figure 4-11 Removing the LCD Assembly Bezel
Removing the Status Display/Inverter Board
1. Remove the LCD Display Bezel.
2. Remove the two screws that hold the Status Display/Inverter Board in place (Figure 4-
12).
3. Remove the cable that goes to the LCD Panel (A).
4. Remove the flat cable assembly (C).
a) Release the cable lock by sliding the lock out of the connector.
b) Remove the cable from the connector.
Remove LCD Display Panel
1. Remove the LCD Display Bezel
2. Remove the four screws that hold the LCD Panel in place (Figure 4-12).
3. Disconnect the cable that goes between the Status Display/Inverter Board and the LCD
Panel. You may have to remove the Inverter Board.
4. Remove the flat cable assembly (B).
a) Release the cable lock by sliding the lock out of the connector.