Technical data

FRU Replacement
Digital HiNote VP 500 Service Guide
4–9
Figure 4-7 Removing LCD Assembly End Caps and Hinge Screws
9. Remove the center cap and the LCD Assembly from the system unit as follows:
a) Press in at the base of the center cap to release the catches.
b) Lift straight up on the LCD assembly and remove the Center cap as you remove the
LCD assembly from the system unit. The LCD cable is still attached to the system
unit.
c) Lay the panel on the work surface behind the system unit being careful not to
damage the cable.
_____________________________ Note____________________________
There are two catches on the back of the center cap that hook on to nibs on the
Keyboard Deck. You may have to slide the cover forward to get these catches to
release.
______________________________________________________________
10. Remove the three screws across the back of the keyboard deck (Figure 4-8).
11. Remove the screw that secures the Keyboard Deck to the motherboard. This screw is
located by the Touch Pad.
12. Disconnect the Touch Pad cable from the motherboard