User`s guide

Chapter 4: Peripheral Devices
Digital HiNote VP 500 Series 4-3
Connecting An External Monitor
Connect an external monitor to the notebook as follows.
1. Connect the monitor signal cable to the notebook’s VGA port located on the
rear of the notebook. Tighten the thumb screws (Figure 4-1, step 1).
2. Connecting the monitor’s power cord to a the wall outlet after ensuring the
monitor is turned off. (Figure 4-1, step 2).
3. Turn on the monitor.
4. Use the [fn + F4] hot key combination to achieve CRT only or simultaneous
viewing mode.
Figure 4-1: Connecting an External Monitor