User`s guide

Chapter 2: Power and Your Computer
Digital HiNote VP 500 Series 2–11
System LEDs
Two System LEDs, on the right side of the notebook's front panel help provide the system’s
power status. The AC Power LED lights green when the notebook is being powered by its AC
Adapter. The Battery Charger LED lights amber when the batteries are being charged. When
the amber LED is off, the batteries are completely charged.
Low Battery Activity
When the battery reaches low battery charge level, a warning beep sounds to remind you to save
your data immediately. Although there is a safety margin of approximately ten minutes, it is
always better to save right away. Pressing the [fn + F7] hot key combination turns off the
system warning beep.
After saving your data, power the notebook using the AC Adapter. If AC power is not
available, turn off the notebook and change the weakened battery will a fully charged one.
To extend battery power, we recommend you make full use of the Notebook’s built-in power
saving features.
Replacing and Disposing of Batteries
When replacing batteries, use only Digital supplied batteries that are compatible with the
notebook computer’s electrical requirements and charging circuitry.
Before recycling or disposing of a battery, protect it against accidentally short circuiting by
placing non-conductive tape across the terminals or conductive surfaces of the battery.
If the battery is not marked, or if you require information about the batteries and their disposal,
consult your nearest Digital Service Center.