Technical data

System Restoration
2-25
6. When prompted, remove the Recovery CD from the
CD-ROM Drive and press the [ctrl]+[alt]+[del] key
combination to restart the system.
7. The system will boot to the C: Drive. Follow the on-
screen instructions to install Windows as usual.
Windows NT System Restoration
This section describes how to restore your system to its original
factory-shipped configuration. If a Microsoft Windows NT 4.0 CD
was packaged with your system, proceed to the section entitled
Restoration using the Microsoft Windows NT CD. If a DIGITAL
Recovery CD was packaged with your system, proceed to the
section entitled Restoration using the DIGITAL Recovery CD.
Restoration using the Microsoft Windows NT CD
This section details how to prepare a new or existing hard drive
for Windows NT 4.0 installation and how to install drivers and
software applications. To complete the process you must have
the DIGITAL HiNote Ultra 2000 System CD and Windows NT
CD which were packaged with your notebook.
This procedure assumes the DIGITAL HiNote Ultra 2000 Media
Dock is not attached to the notebook.
1. Ensure that the notebook is powered off and insert the
CD-ROM Drive Module.
2. Power on the system.
3. Enter the System Setup Utility by pressing the [fn] + [F3]
key combination during POST (Power On Self Test).
4. Enable the CD-ROM Boot option in the System menu.
5. Place the Windows NT CD into the CD-ROM Drive.