Technical data

System Restoration
2-5
3. Once all the Windows 95 files have been copied to the
hard drive, power down the system and replace the CD-
ROM Drive Module with the Diskette Drive Module.
Ensure that the Diskette Drive contains no diskettes and
both CardBus slots are empty.
4. Power on the system. When prompted press the [fn] +
[F3] key combination to enter the Setup Utility. Disable
CD-ROM Boot Option. Save changes and Exit. The
notebook will reboot. Refer to the DIGITAL HiNote Ultra
2000 User’s Guide for detailed instructions on
configuring the Setup Utility.
5. After disabling the CD-ROM boot option and the system
is booted, the Windows 95 boot screen will appear. Hit
any key to continue and then follow the on-screen
instructions.
6. When prompted for type of installation, choose Typical.
7. When the Analyzing Your Computer window appears,
do NOT select any additional devices for detection from
the list provided.
8. When prompted with the Windows Components
window, select the Most Common Components option.
When Windows 95 installation is complete, any
additional components can be installed using the
Add/Remove Programs wizard via the Control Panel.
9. When prompted to make a Windows 95 Startup
diskette, it is strongly recommended to do so. You will
need a blank formatted 1.44 MB diskette for this
operation.
10. At the completion of this phase of the Windows 95
installation, you will be prompted to select [Finish] to
restart the computer so the changes can take effect.