Technical data

System Restoration
2-3
3. Ensure that the Serial and Infrared Ports are both set
to “Auto set by PnP” and enable the CD-ROM Boot
option. Refer to the DIGITAL HiNote Ultra 2000 User’s
Guide for detailed instructions on configuring the Setup
Utility.
4. Place the DIGITAL HiNote Ultra 2000 System CD into
the CD-ROM Drive.
5. Select the Save & Reboot option from the Setup Utility
Exit menu. Note the drive letter assigned to the CD-
ROM during bootup. The system will boot to the
DIGITAL HiNote Ultra 2000 System CD.
Formatting the Hard Drive
CAUTION
: This procedure will erase all data
residing on the Hard Disk Drive. Before
proceeding, ensure all important files are backed
up.
This procedure assumes the DIGITAL HiNote Ultra 2000 Media
Dock is not attached to the notebook.
1. When the system boots to the DIGITAL HiNote Ultra
System CD, the system will prompt you whether or not
you want to continue booting using this CD, press [Y].
Then a second screen will appear prompting you to
press any key to continue, press the Space bar. An
action menu will appear.
2. Select option 2 to initialize and partition a new hard drive
using the FDISK utility.
When running FDISK, you will be prompted whether or
not to enable large disk (FAT32) support. Choose No to
enable FAT16. Also make sure you set the Active
Partition flag to make it bootable.