Technical data

Parts Replacement
DIGITAL HiNote Ultra 2000 Service Guide
4–33
14.1 Inch LCD Display
LCD Panel
To remove the 14.1 inch LCD Panel:
1. Remove the Keyboard Deck and LCD Assembly (Figure 4-7, Figure 4-8, Figure 4-9,
Figure 4-10).
2. Remove the LCD Bezel (Figure 4-29).
3. Remove the filler strips located on the left and right side of the LCD Display. These strips
cover the screws that hold the LCD Panel in place.
______________________________ Note ___________________________
Remove each filler strip slowly so the adhesive does not come off the filler strip.
______________________________________________________________
4. Remove the four screws (two on each side) the hold the LCD Panel in place (Figure 4-33).
5. Remove the screw located in the lower right hand corner of the LCD Assembly (Figure 4-
33).
6. Disconnect the inverter cable (located to the right of the Status Display) and display cable
(Figure 4-33).
7. Remove the screw that holds the LCD display cable Assembly in place (located to the left
of the Status Display, Figure 4-33).
8. Disconnect the LCD display cable.
9. Remove the LCD Panel.
______________________________ Note ___________________________
When reinstalling the 14.1 inch LCD Panel:
1. Be careful not to pinch the cable that goes from from the inverter to the
backlight.
2. Make sure you secure the flat backlight cable under screw to hold it in place.
______________________________________________________________