Technical data

System BIOS
DIGITAL HiNote Ultra 2000 Service Guide
2–11
Default Features
Feature Settings Comments
Save User Default
Settings
Stores the current Setup values as the user default
values in non-volatile memory.
Load User Default
Settings
Loads all values stored under User Defaults as the
new system values.
Load Factory
Default Settings
Loads all values to their Factory Default Settings.
Exit Features
Feature Settings Comments
Save Saves all Setup values and exit Setup.
Quit Ignores all changes to Setup values and exits Setup.
About Supplies some BIOS and system version
information.
Restoring the Flash BIOS
To restore a corrupted Flash BIOS a Crisis Recovery diskette is required.
To restore the Flash BIOS:
1. Turn the computer Off by pressing [fn] + Standby/Resume button.
2. Make sure the Diskette Drive Module is installed in the computer.
3. Enable Crisis Recovery mode by placing a jumper across resistor R744. This resistor is
located in the expansion memory compartment on the bottom of the unit. To locate the
resistor:
a) Place the unit in front of you with the bottom up and the battery closest to you.
b) Remove the cover on the memory compartment.
c) The resistor is located in the lower left corner of the memory compartment.
4. Place the Crisis Recovery disk in the drive.
5. Turn On the system. When the BIOS is restored, turn Off the system by pressing [fn] +
Suspend/Resume button.
6. Remove the jumper across resistor R744.