User`s guide

Contents
Appendix A. Specifications A-1
Input Power Requirements.............................................................................A-1
Power Units...................................................................................................A-1
Controller Power Requirements.....................................................................A-2
Physical Specifications..................................................................................A-3
Environmental Specifications........................................................................A-4
SBB Environmental Stabilization..................................................................A-6
Appendix B. Illustrated Parts List B-1
Appendix C. MS-DOS Verification Procedure C-1
Verifying the Subsystem under MS-DOS.......................................................C-1
Using the Controller under Windows V3.1 ....................................................C-2
Figures
1-1. Logical RAID Drive State Diagram........................................................1-6
3-1. Jumper Location on the 1-Channel Controller ........................................3-2
3-2. Removing a Bezel..................................................................................3-4
3-3. Removing the Blowers ...........................................................................3-5
3-4. Terminator and Jumper Locations ..........................................................3-6
3-5. SHELF_OK Jumper on the Terminator ..................................................3-7
3-6. SHELF_OK Jumper on the Jumper.........................................................3-8
3-7. Removing a Disk Drive or a Blank Panel ...............................................3-9
3-8. External Cable Routing ..........................................................................3-10
3-9. Cable Connections .................................................................................3-11
3-10. Device Labels.......................................................................................3-13
4-1. Jumper Location on the 3-Channel Controller ........................................4-2
4-2. Internal Cable Connections for the 3-Channel Controller .......................4-3
4-3. Removing a Bezel..................................................................................4-5
4-4. Removing the Blowers ...........................................................................4-6
4-5. Terminator and Jumper Locations ..........................................................4-7
4-6. SHELF_OK Jumper on the Terminator ..................................................4-8
viii