User`s guide

StorageWorks RAID Array 200 Subsystem Family
Invoking the Utilities
You can invoke the utilities on an Intel system or an AXP system. If you have an
Intel system, refer to the "Invoking the Utilities on Intel Systems" section of this
chapter. If you have an AXP system, refer to the "Invoking the Utilities on AXP
Systems" section of this chapter.
Before you power on and boot your system to invoke the utilities, be sure that all
storage pedestals are powered on.
When you invoke the utilities, the software checks the status of each drive. If the
drive status changes after you invoke the utilities (for example, if a drive fails or if
you remove a drive), the change does not display until the next time you invoke the
utilities.
Invoking the Utilities on Intel Systems
1. Insert the Standalone RAID Array 200 Software Vx.x for Intel
Systems diskette in your floppy drive and boot from that drive.
2. Enter this command at the prompt:
A:\SWXCR> SWXCRMGR
After checking the drives, the system displays the main menu of the
utilities as shown in Figure 5-1.
5-4