User`s guide

StorageWorks RAID Array 200 Subsystem Family
System Requirements
You must have the following to run the utility:
•
An Intel or Alpha AXP system with a VGA monitor and a keyboard
•
One floppy disk drive (3.5-inch, 1.44 MB)
•
SWXCR controller installed and all disk drives connected and powered on.
Before You Begin
Make a backup copy of the Standalone RAID Array 200 Software diskettes (the Intel
x86 or AXP diskette, whichever you are using on your system) on a PC using this
procedure.
1. Copy the diskette using the MS-DOS diskcopy command (see your MS-DOS
manual for detailed instructions on how to use this command).
2. Label the new diskette and store the original diskette in a safe place.
5-2