User`s guide

Chapter 4
20. Insert the drives into the storage pedestal according to the layout shown in
Figure 4-11.
21. To support the hot swap option, verify that all power supply SBBs
(BA35X-HA) are Rev. L01 or later.
22. Insert the optional redundant power supply SBBs into the designated slots.
See Figure 4-11.
23. Thread the female end of the ac power cable under the handle of each storage
pedestal. Connect the cable to the ac receptacle on the ac distribution unit.
The ac extension cable is not used in this configuration.
24. Connect the other end of the ac power cable to an ac power source.
25. Replace the front and rear bezel doors.
26. Power up the storage pedestal.
27. Power up the host system.
28. On Intel systems with the BIOS enabled, you can confirm proper installation
of the RAID controller when you see a message similar to the following
during the boot process.
SWXCR BIOS Version x.x
Digital Equipment Corporation
SWXCR Firmware Version x.x
SWXCR RAM: x Mbytes
If you do not get a similar message, refer to Chapter 6 of this manual for
troubleshooting and service information.
At this point, you used the ECU to inform your host system about the new RAID
controller (Chapter 2) and you added the RAID controller (this chapter). Now turn to
Chapter 5 to configure the RAID controller to use the disk devices.
4-15