User`s guide

Chapter 4
14. Thread the Y-cable connector labeled Channel 1 under the rear handle of
Pedestal 1, and through the opening at the top of the pedestal. See
Figure 4-9.
15. Loop the Channel 1 connector down below the divider plate of Pedestal 1 and
connect the cable to connector JA1 (upper-left connector when viewed from
the front) on the storage pedestal. See Figure 4-10.
16. If you are using a third storage pedestal, thread the Y-cable connector labeled
Channel 2 under the rear handle of Pedestal 2, and through the opening at the
top of the storage pedestal. See Figure 4-9. If you are not using Pedestal 2,
coil the Channel 2 cable.
17. Loop the Channel 2 connector down below the divider plate of Pedestal 2 and
connect the cable to connector JA1 (upper-left connector viewed from the
front) on the storage pedestal. See Figure 4-10.
18. Insert the 68-pin connector into the external channel 1/2 connector on the
bulkhead of the host system. See Figure 4-10.
19. After you consult the pedestal configuration diagram (Figure 4-11), label the
disk drives with this information:
•
Device type
•
Channel
•
SCSI ID
For example:
Dev: RZ26L
CH: 0
ID: 1
4-13