User`s guide

Chapter 3
22. On Intel systems with the BIOS enabled, you can confirm proper installation
of the RAID controller when you see a message similar to the following
during the boot process.
SWXCR BIOS Version x.x
Digital Equipment Corporation
SWXCR Firmware Version x.x
SWXCR RAM: x Mbytes
If you do not get these messages or the installation aborts, refer to Chapter 6 of this
manual for troubleshooting and service information.
At this point, you used the ECU to inform your host system about the new RAID
controller (Chapter 2) and you added the RAID controller (this chapter). Now turn to
Chapter 5 to configure the RAID controller to use the disk devices.
3-15