User`s guide

StorageWorks RAID Array 200 Subsystem Family
6. Remove the second blower to see the whole backplane.
The appearance of the backplane depends upon the version of the
StorageWorks storage pedestal that you have. After you remove the blowers,
determine if your pedestal has jumper pins next to the Slot 2 connector on the
rear of the backplane. See blowup of detail on Figure 3-4.
Figure 3-4. Terminator and Jumper Locations
•
If jumper pins are not present on the backplane and the terminator and
jumper are installed as shown in Figure 3-4, go to Step 7.
•
If jumper pins are present, install a jumper in the Shelf_OK_External_Cables
position as in Figure 3-4.
3-6