User`s guide

Chapter 3
Installing the Cable and the Storage Pedestal
This section describes the cabling and installation procedure for the storage pedestal.
If you are installing a system with embedded disk drives, refer to that system's
documentation for instructions on cabling.
______________________ NOTE ____________________________
If the SCSI port is set to the default values of synchronous and 10 MB/s
(FAST), the total cable length cannot exceed three meters (two meters for
the cable and one meter for the storage pedestal).
To install the storage pedestal and make the cable connections, follow these steps.
1. Unpack the BN21H-02 cable and the storage pedestal. Place the storage
pedestal where it is to be used. Label it Pedestal 0.
2. Unlock and open the front and rear bezel doors. See Figure 3-2.
3-3