User`s guide

Chapter 2
16. Select the Save and exit option (Step 5 in this example) and press the Enter
key. Your screen displays a message similar to the following.
EISA Configuration Utility Help=F1
Your configuration file has been saved, and if possible a backup SYSTEM.SCI file
has been made on the current drive.
To complete your configuration, you must do one of the following:
If you need to install boards or change switches and jumpers on boards already
installed, turn off your computer and do so.
If you want to test your system or install an operating system, press ENTER to
restart your computer, run the configuration utility again, and select the appropriate
main menu item.
If you are finished configuring, remove the SYSTEM CONFIGURATION diskette if
it is in drive A and press ENTER to restart your computer.
Ok=ENTER
17. Follow the directions on your screen displays until you save and exit the
ECU.
18. Remove the diskette and turn off the host system.
•
If you are installing an SWXCR-EA 1-channel controller, go to
Chapter 3 to continue with the hardware installation of your
subsystem.
•
If you are installing an SWXCR-EB 3-channel controller, go to
Chapter 4 to continue with the hardware installation of your
subsystem.
2-13