User`s guide

StorageWorks RAID Array 200 Subsystem Family
Running the ECU
______________________ NOTE____________________________
At any time, you can press the ESC key to exit the ECU and begin again.
To run the ECU, follow these steps:
1. Remove the cover from your system and locate the empty board slots. The
SWXCR controller is an EISA DMA (direct memory access) device. Refer
to your system documentation for any restrictions about installing such
devices. For more information about using the ECU on your system, refer to
your system documentation.
2. Boot from your system ECU configuration diskette. Select the function that
configures your system and press the Enter key.
______________________ NOTE____________________________
ECUs differ from system to system. Check the procedures in this guide
before you respond to screen prompts.
2-2