User`s guide

StorageWorks RAID Array 200 Subsystem Family
Step
Action
Result
5
Install the new controller with the
old EEPROM into the same EISA
slot that the original controller was
in. Connect the cable(s) to the
storage pedestal(s) and power on the
pedestal(s).
6
Power on the system.
The system displays the following
message:
Mismatch between
NVRAM and flash
EEPROM configuration.
Spinning up drives...
7
Invoke the utilities as described in
Chapter 5.
The utilities display the following
message:
The NVRAM and flash
EEPROM configurations
do not match
Proceeding further
will allow selection
between NVRAM and
Flash configurations.
Press any key to
continue
Continued on the next page.
6-36