User`s guide

Chapter 6
Removal and Replacement
This section describes the following:
•
Replacing a drive SBB
•
Replacing a power supply SBB
•
Replacing a blower
•
Replace an SWXCR controller
Replacing a Drive SBB
______________________CAUTION ___________________________
Once a device has been configured by the SWXCR controller, moving the device
to another bus or changing the device address can cause problems or loss of data.
______________________CAUTION ___________________________
Ensure the replacement SBB is the same type as the one being replaced. Also,
always use both hands when handling a device and be careful not to touch the
device connector to prevent electrostatic discharge damage.
6-25