User`s guide

Chapter 6. Configuring Your Array
EK–SWRA2–IG. C01 6–9
6.3.1.2 Setting the SCSI Transfer Parameters
To set the SCSI Transfer Parameters, follow these steps.
1. Use the arrow keys to highlight the SCSI Xfr Parameters option on the
Edit/View Parameters menu and press the Enter key. An Enter Channel #
box appears, similar to the one shown in Figure 6–6, at the bottom right of
the screen.
Figure 6–6 Enter Channel Box Appears at Bottom Right
2. Enter a channel number of the attached controller and press the Enter key.
The SCSI Transfer Parameters of Channel x screen appears similar to the
one shown in Figure 6–7. The Data transfer rate option appears highlighted.