User`s guide

Chapter 6. Configuring Your Array
EK–SWRA2–IG. C01 6–7
Figure 6–4 The Edit/View Parameters Menu
6.3.1.1 Completing the Controller Parameters
To set the Controller Parameters, follow these steps.
1. Use the arrow keys to highlight the Data Parameters option on the Edit/View
Parameters menu and press the Enter key. The Physical Parameters screen
appears, similar to the one shown in Figure 6–5, with the Default rebuild
rate option highlighted.
2. Press the Enter key and a box appears at the bottom right corner of the
screen in which you can type a rebuild rate from 0–50. The default rebuild
rate, 50, is the fastest rate at which the system will rebuild data from a failed
drive. You can not change the rebuild rate for a rebuild in progress.
3. Use the arrow keys to highlight the Stripe size option.