User`s guide

Chapter 5. 3-Channel RAID Controller Installation
EK–SWRA2-IG. C01 5–19
5.2.3 Power Cable Installation
1. Open the rear bezel door of each pedestal and remove the rear bezel by
pressing down on the locking tabs at the bottom of each bezel.
2. Thread the end of the ac power cable under the handle of the pedestal base
and connect the cord to the ac receptacle on the ac distribution unit. (See
Figure 5–16.)
3. Connect the end of the ac power cable to an ac power source.
4. Replace the front and rear bezel doors.
5. Power up the storage pedestal.
6. Power up the host computer system.
Figure 5–16 Power Cable Connection