User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
5–18 EK–SWRA2–IG. C01
5.2.2.4 Labeling the Installed Drives
Label the disk drives that are installed in the Expansion Storage Pedestal to
identify their Device Type, Channel, and SCSI ID (for example, Dev: RZ26L,
CH: 0, ID: 1) (see Figure 5–15).
NOTE
The SCSI ID is determined by the slot number in
the Expansion Storage Pedestal, as shown in Fig-
ure 5–15. Each pedestal (channels 0, 1, and 2)
has SCSI ID numbers 0 through 6 corresponding
to slots 0 through 6.
To support the Expansion Storage Pedestal’s hot swap option, check the label on
the power supply SBB to ensure it is BA35X-HA Rev. L01 or later.
Figure 5–15 Device Labels