User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
5–6 EK–SWRA2–IG. C01
5.1.2 PCI Controller Internal Cabling
1. Orient the internal bus ribbon cable as shown in Figure 5-4 (PCI). Insert the
90 degree connector of the internal ribbon cable into the internal channel-2
edge connector on the PCI controller.
2. Fold the cable as shown.
3. Attach the bulkhead panel with its 68-pin connector to the host system bulk-
head and tighten the screw.
Figure 5–4 Internal Cable Connections for the 3-Channel PCI Controller