User`s guide

Chapter 5. 3-Channel RAID Controller Installation
EK–SWRA2-IG. C01 5–3
6. Install the RAID controller board.
NOTE
On some computer system bulkheads, various
size knockout panels are provided for mounting
external connectors. The channel-1/channel-2
EISA internal cable connector or the channel-2
PCI internal cable connector can be mounted in
one of these knockout panels.
• EISA computer – in the slot selected when you ran the ECU. If a mother-
board slot must be used for the channel-1/channel-2 bulkhead connector, it
is suggested that the board be placed where there is a vacant slot adjacent to
the EISA board.
• PCI computer – in any available PCI slot. If a motherboard slot must be
used for the external channel-2 connector, it is suggested that the board be
placed in the PCI slot adjacent to an EISA slot and the EISA slot used for
the external connector. When the system is powered-on, the host system
will locate and establish communications with the PCI board.
Figure 5–1 Board Layout of the 3-Channel Controller (EISA Version)
Internal
Channel 2
Cache Module
JP3
External
Channel 0
JP4
JP5
Internal
Channel 1
Internal
Channel 0
MR0217