User`s guide

Chapter 4. 1-Channel RAID Controller Installation
EK–SWRA2-IG. C01 4–13
7. On Intel systems with the BIOS enabled, a message similar to the following
will appear during the boot process. This confirms proper installation of the
RAID Controller.
SWXCR BIOS Version v.v
Digital Equipment
Corporation
SWXCR Firmware Version
x.x
SWXCR RAM: x Mbytes
or
The equivalent for PCI
If the message does not appear or the boot process aborts, refer to Chapter 8,
Troubleshooting.
Compare the BIOS version shown on the monitor with the BIOS version listed in
the Release Notes.
• If the version shown on the monitor is earlier (lower) than that listed in the
Release Notes, go to Section 9.5 and update the BIOS. Then return here and
continue with step 7.
• If the version shown on the monitor is the same as that listed in the Release
Notes, BIOS update is not required. continue this installation procedure.