User`s guide

StorageWorks RAID Array 200 Controller Installation and Standalone Configuration Utility
4–12 EK–SWRA2–IG. C01
4.2.3 Power Cable Installation
1. Remove the rear bezel.
2. Thread the female end of the ac power cable under the handle of the pedestal
base and connect the cord to the ac receptacle on the ac distribution unit. (See
Figure 4-12).
3. Connect the other end of the ac power cable to an ac power source.
4. Replace the front and rear bezel doors.
5. Power up the storage pedestal.
6. Power up the host computer system.
Figure 4–12 Power Cable Connection